STEERING ANGLE SENSOR (for Hatchback) > INSTALLATION |
| 1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Check that the ignition switch is turned off.
Check that the negative battery terminal is detached.
Check that the front tires face straight forward.
Check that the turn signal switch is in the neutral position.
Engage the 3 claws and install the spiral cable with sensor sub-assembly.
Connect the steering sensor connector to the spiral cable with sensor sub-assembly.
Connect the airbag connector to the spiral cable with sensor sub-assembly.
Connect the horn connector to the spiral cable with sensor sub-assembly.
| 2. INSTALL UPPER STEERING COLUMN COVER |
Engage the claw to install the upper steering column cover.
| 3. INSTALL LOWER STEERING COLUMN COVER |
Engage the 4 claws to install the lower steering column cover.
Install the 3 screws.
| 4. ADJUST SPIRAL CABLE |
Check that the ignition switch is turned off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Confirm that the front tires face straight forward.
Center the spiral cable.
![]() |
Turn the spiral cable counterclockwise until it locks.
![]() |
Turn the spiral cable 2.5 times clockwise from its locked position and align the alignment marks.
| *a | Alignment Mark |
| 5. INSTALL STEERING WHEEL ASSEMBLY |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. CHECK SRS WARNING LIGHT |