STEERING ANGLE SENSOR (for Hatchback) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE STEERING WHEEL ASSEMBLY |
| 4. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Remove the 3 screws.
![]() |
Disengage the 4 claws and remove the lower steering column cover.
| 5. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Disengage the claw and remove the upper steering column cover.
| 6. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
![]() |
Disconnect the horn connector from the spiral cable with sensor sub-assembly.
Slide the slider and disconnect the airbag connector from the spiral cable with sensor sub-assembly.
| *1 | Slider |
Disconnect the steering sensor connector from the spiral cable with sensor sub-assembly.
![]() |
Disengage the 3 claws and remove the spiral cable with sensor sub-assembly.