Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY (for Hatchback Fold Down Seat Type)

REAR SEAT ASSEMBLY (for Hatchback Fold Down Seat Type) > DISASSEMBLY

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE BENCH TYPE REAR SEAT CUSHION COVER (for TMC Made)


    B349741
  1. Remove the 44 hog rings and the bench type rear seat cushion cover from the bench type rear seat cushion pad.



2. REMOVE BENCH TYPE REAR SEAT CUSHION COVER (for TMMF Made)


    B349742
  1. Disengage the 30 hooks.

  1. Pass the 3 plastic plates of the bench type rear seat cushion cover through the bench type rear seat cushion pad and remove the bench type rear seat cushion cover.



3. REMOVE REAR SEAT HEADREST ASSEMBLY
  1. Remove the 2 rear seat headrest assemblies.



4. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY
  1. Remove the rear seat center headrest assembly.



5. REMOVE REAR SEATBACK COVER

HINT:
B272786E04
Use the same procedure for the remaining parts.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws to remove the rear seatback cover.
    Text in Illustration 
    *a
    Protective Tape



6. REMOVE REAR SEATBACK LOCK RELEASE BUTTON

HINT:
B272898
Use the same procedure for both sides.

  1. Turn the rear seatback lock release button in the direction indicated by arrow to remove it.



7. REMOVE REAR SEATBACK STOP BUTTON GROMMET

HINT:
B272886
Use the same procedure for both sides.

  1. Disengage the 2 claws to remove the rear seatback stop button grommet.



8. REMOVE REAR SEAT HEADREST SUPPORT


B287824
  1. Disengage the hook.



    B287823
  1. Disengage the 2 hooks and unfasten the 2 zippers.



    B287826
  1. Disengage the 12 claws to remove the 6 rear seat headrest supports.



9. REMOVE REAR SEATBACK FRAME SUB-ASSEMBLY


B287822
  1. Remove the rear seatback frame sub-assembly.



10. REMOVE REAR SEATBACK LOCK ASSEMBLY RH


    B272902
  1. Remove the 2 bolts and the rear seatback lock assembly RH from the rear seatback frame sub-assembly.



11. REMOVE REAR SEATBACK LOCK ASSEMBLY LH

HINT:
Use the same procedure as for the RH side.



12. REMOVE SEPARATE TYPE REAR SEATBACK COVER (for TMC Made)


    B287785
  1. Remove the 12 hog rings and the separate type rear seatback cover from the separate type rear seatback pad.



13. REMOVE SEPARATE TYPE REAR SEATBACK COVER (for TMMF Made)


    B351902
  1. Disengage the 14 hooks to remove the separate type rear seatback cover from the separate type rear seatback pad.