REAR SEAT ASSEMBLY (for Hatchback Fold Down Seat Type) > REASSEMBLY |
| 1. INSTALL SEPARATE TYPE REAR SEATBACK COVER (for TMC Made) |
![]() |
Using hog ring pliers, install the separate type rear seatback cover to the separate type rear seatback pad with 12 new hog rings.
| *1 | Hog Ring |
| *a | Hog Ring Pliers |
| 2. INSTALL SEPARATE TYPE REAR SEATBACK COVER (for TMMF Made) |
![]() |
Engage the 14 hooks to install the separate type rear seatback cover to the separate type rear seatback pad.
| 3. INSTALL REAR SEATBACK LOCK ASSEMBLY RH |
![]() |
Install the rear seatback lock assembly RH with the 2 bolts.
| 4. INSTALL REAR SEATBACK LOCK ASSEMBLY LH |
| 5. INSTALL REAR SEATBACK FRAME SUB-ASSEMBLY |
![]() |
Temporarily install the rear seatback frame sub-assembly.
![]() |
Fasten the 2 zippers and engage the 2 hooks.
![]() |
Engage the hook to install the rear seatback frame sub-assembly.
| 6. INSTALL REAR SEAT HEADREST SUPPORT |
![]() |
Align the protruding portion of the rear seat headrest support with the installation groove of the rear seatback frame sub-assembly.
| *a | Protruding |
Disengage the 12 claws to remove the 6 rear seat headrest supports.
| 7. INSTALL REAR SEATBACK STOP BUTTON GROMMET |
![]() |
Engage the 2 claws to install the rear seatback stop button grommet.
| 8. INSTALL REAR SEATBACK LOCK RELEASE BUTTON |
![]() |
Turn the rear seatback lock release button in the direction indicated by arrow to install it.
| 9. INSTALL REAR SEATBACK COVER |
![]() |
Engage the 4 claws to install the rear seatback cover.
| 10. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY |
Install the rear seat center headrest assembly.
| 11. INSTALL REAR SEAT HEADREST ASSEMBLY |
Install the 2 rear seat headrest assemblies.
| 12. INSTALL BENCH TYPE REAR SEAT CUSHION COVER (for TMC Made) |
![]() |
Using hog ring pliers, install the bench type rear seat cushion cover to the bench type rear seat cushion pad with 44 new hog rings.
| *1 | Hog Ring |
| *a | Hog Ring Pliers |
| 13. INSTALL BENCH TYPE REAR SEAT CUSHION COVER (for TMMF Made) |
![]() |
Pass the 3 plastic plates of the bench type rear seat cushion cover through the bench type rear seat cushion pad.
Engage the 30 hooks and install the bench type rear seat cushion cover.