Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for Sedan)

COMPRESSOR (for Sedan) > ON-VEHICLE INSPECTION



1. INSPECT COMPRESSOR AND PULLEY


  1. Check the operation.


    I101613


    1. Start the engine.

    2. Inspect the weight hub.

      Standard:
      The weight hub rotates along with the pulley.



    E061224E02
  1. Measure the resistance between terminals 1 and 2.

    Standard resistance:
    10.1 to 11.1 Ω at 25°C (77°F)

    If the resistance is not as specified, replace the compressor and pulley.