FRONT DOOR SPEAKER (for Sedan) > INSTALLATION |
| 1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY |
![]() |
Using an air riveter or hand riveter, install the front No. 1 speaker with 3 new strike rivets.
![]() |
![]() |
![]() |
Connect the speaker connector.
| 2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
w/ Power window:
Connect the front door lock remote control cable and front door inside locking cable.
![]() |
Engage the 9 clips and install the front door trim board.
![]() |
Install the screw.
w/o Power window:
![]() |
Connect the front door lock remote control cable and front door inside locking cable.
![]() |
Engage the 9 clips and install the front door trim board.
![]() |
Tighten the screw.
| 3. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL |
![]() |
for Driver side with power window:
Connect the connector.
Engage the 7 claws and 2 clips and install the front armrest base upper panel.
Install the screw.
![]() |
for Front passenger side with power window:
Connect the connector.
Engage the 7 claws and 2 clips and install the front armrest base upper panel.
Install the screw.
![]() |
w/o Power window:
Engage the 5 clips and 2 clips and install the front armrest base upper panel.
Install the screw.
| 4. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH |
![]() |
Engage the claw and clip and install the front door lower frame bracket garnish.
| 5. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
![]() |
Install the window regulator handle plate.
Open all the windows.
![]() |
Install the front door window regulator handle with the clip at the angle shown in the illustration.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |