FRONT DOOR SPEAKER (for Sedan) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
![]() |
Insert a clip remover between the plate and door trim.
Turn the handle with the clip remover inserted, as shown in the illustration.
Remove the front door window regulator handle and clip.
Remove the window regulator handle plate.
| 3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH |
![]() |
Disengage the claw and clip and remove the front door lower frame bracket garnish.
| 4. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL |
![]() |
for Driver side with power window:
Remove the screw.
Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.
Disconnect the connector.
![]() |
for Front passenger side with power window:
Remove the screw.
Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.
Disconnect the connector.
![]() |
w/o Power window:
Remove the screw.
Disengage the 5 claws and 2 clips and remove the front armrest base upper panel.
| 5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
w/ Power window:
Remove the screw.
![]() |
Disengage the 9 clips.
![]() |
Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board.
![]() |
w/o Power window:
Remove the screw.
![]() |
Disengage the 9 clips.
![]() |
Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board.
| 6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY |
![]() |
Disconnect the speaker connector.
![]() |
Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.157 in.), and remove the front No. 1 speaker.
Operate the drill around the rivet head circumference and cut out the flange.
After drilling out the flange, continue drilling to push out the shards on the drill.
Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.