SPIRAL CABLE (for Hatchback) > INSPECTION |
| 1. INSPECT SPIRAL CABLE SUB-ASSEMBLY |
If there are any defects as mentioned below, replace the spiral cable sub-assembly with a new one:
![]() |
Inspect the spiral cable sub-assembly.
| *a | Component without harness connected (Spiral Cable Sub-assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A-1 - C8 (HO) | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| A-8 - C-4 (EAU) | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| A-9 - C-5 (AU2) | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| A-10 - C-6 (AU1) | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| B-3 - C-1 (CCS) | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| B-4 - C-2 (ECC) | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| D-1 - E-2 (D+) | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| D-2 - E-1 (D-) | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| D-3 - F-1 (D2+) | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| D-4 - F-2 (D2-) | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right |