STEERING PAD (for Hatchback) > INSTALLATION |
| 1. INSTALL STEERING PAD |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Connect the 2 airbag connectors.
| *1 | Locking Button |
Connect the horn terminal.
![]() |
Engage the 3 pins with the 3 snap rings to install the steering pad.
| 2. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
Engage the 2 claws to install the lower No. 2 steering wheel cover.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. INSPECT SRS WARNING LIGHT |