CENTER AIRBAG SENSOR ASSEMBLY (for Hatchback) > INSTALLATION |
| 1. INSTALL AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Install the airbag sensor assembly with the 3 bolts.
Check that there is no looseness by shaking the airbag sensor assembly.
![]() |
Connect the connector holder to lock the lever.
| *1 | Lever |
![]() |
Check that the drip-proof sheet has not been removed and does not cut into the connectors.
| *1 | Drip-proof Sheet |
| 2. INSTALL REAR CONSOLE BOX ASSEMBLY |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION (for Hatchback with VSC/Built-in Type Yaw Rate Sensor) |
| 5. INSPECT SRS WARNING LIGHT |