FRONT AIRBAG SENSOR (for Hatchback) > INSTALLATION |
| 1. INSTALL FRONT AIRBAG SENSOR |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Insert the 2 pins (stopper) into the body hole and install the front airbag sensor with the 2 bolts.
Connect the connector to the front airbag sensor.
Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).

| *1 | Housing Lock | *2 | CPA |
| *a | Connection is Completed | - | - |
Check that there is no looseness in the installation parts of the front airbag sensor.
| 2. INSTALL HEADLIGHT ASSEMBLY |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. INSPECT SRS WARNING LIGHT |