Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR (for Sedan)

FRONT WIPER MOTOR (for Sedan) > INSPECTION

for Preparation Click here



1. INSPECT FRONT WIPER MOTOR


E104082E01
  1. Check the LO operation.

    1. Connect the positive (+) battery lead to terminal 5 (+1) of the connector and the negative (-) battery lead to terminal 4 (E), then check that the motor operates at low speed (LO).

      Standard:
      Motor operates at low speed (LO).

      If the result is not as specified, replace the motor.

  1. Check the HI operation.

    1. Connect the positive (+) battery lead to terminal 3 (+2) of the connector and the negative (-) battery lead to terminal 4 (E), then check that the motor operates at high speed (HI).

      Standard:
      Motor operates at high speed (HI).

      If the result is not as specified, replace the motor.



  1. Check the automatic stop operation.

    1. Connect the positive (+) battery lead to terminal 5 (+1) of the connector and the negative (-) battery lead to terminal 4 (E). With the motor operating at low speed (LO), disconnect terminal 5 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

    2. Using SST, connect terminals 1 (S) and 5 (+1). Connect the positive (+) battery lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

      SST
      09843-18040  



    3. E113864E03
    4. Check that the motor stops automatically in the automatic stop position.

      Standard:
      Refer to the illustration.

      If the result is not as specified, replace the motor assembly.