Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR (for Sedan)

AIR CONDITIONING PRESSURE SENSOR (for Sedan) > ON-VEHICLE INSPECTION



1. INSPECT PRESSURE SENSOR


    E110988E04
  1. Check the wire harness.

    1. Disconnect the connector of the pressure sensor.

    2. Using an ohmmeter, measure the resistance of the wire harness side connector.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - Body ground
      Below 1 Ω

    3. Turn the ignition switch ON.

    4. Measure the voltage of the wire harness side connector.

      Standard voltage:
      Tester Connection
      Specified Condition
      1 - 3
      4.7 to 5.3 V



    I101567E05
  1. Check the pressure sensor.

    1. Set the manifold gauge.

    2. Connect the connector to the pressure sensor.

    3. Warm up the engine.

    4. Switch A/C ON.

    5. Using a voltmeter, measure the voltage between connector terminals 6 (PRE) and 11 (SG-1) of the air conditioner amplifier.

      HINT:
      Check from the rear of the connector while it is connected to the air conditioning amplifier.

      Standard voltage:
      Refrigerant Pressure
      Specified Condition
      196 to 3140 kPa (2.0 to 32.0 kgf/cm2, 28 to 455 psi)
      0.76 to 4.74 V