Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR (for Hatchback)

AIR CONDITIONING PRESSURE SENSOR (for Hatchback) > ON-VEHICLE INSPECTION



1. INSPECT AIR CONDITIONER PRESSURE SENSOR


    E208778E06
  1. Check the wire harness.
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Air Conditioner Pressure Sensor)

    1. Disconnect the A60 air conditioner pressure sensor connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      A60-1 (-) - Body ground
      Always
      Below 1 Ω

    3. Turn the ignition switch to ON.

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      A60-3 (+) - Body ground
      Ignition switch ON
      4.75 to 5.25 V



    I106305E02
  1. Check the air conditioner pressure sensor.
    Text in Illustration 
    *a
    Component with harness connected
    (Air Conditioning Amplifier Assembly)

    1. Set the manifold gauge.

    2. Connect the connector to the air conditioner pressure sensor.

    3. Warm up the engine.

    4. A/C switch on.

    5. Using a voltmeter, measure the voltage between connector terminals 7 (PRE) and 5 (SG-2) of the air conditioning amplifier assembly.

      HINT:
      Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.

      Standard Voltage:
      Tester Connection
      Refrigerant Pressure
      Specified Condition
      D130-7 (PRE) - D130-5 (SG-2)
      196 to 3140 kPa
      (2.0 to 32.0 kgf/cm2, 28 to 455 psi)
      0.66 to 4.88 V