Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM (for Hatchback)

POWER DOOR LOCK CONTROL SYSTEM (for Hatchback) > All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch


DESCRIPTION

The main body ECU receives switch signals from the door control switch and activates the door lock motor on each door according to these signals.

WIRING DIAGRAM


B262783E02


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (DOOR CONTROL SWITCH)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. According to the display on the Techstream, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Door Lock SW-Lock
    Door manual lock switch signal / OFF or ON
    OFF: Door control switch is turned to unlock position
    ON: Door control switch is turned to lock position
    -
    Door Lock SW-Unlock
    Door manual unlock switch signal / OFF or ON
    OFF: Door control switch is turned to lock position
    ON: Door control switch is turned to unlock position
    -

    OK:
    The Techstream indicates ON or OFF according to the switch operation shown in the table.



NG
Go to step 2
OK

REPLACE MAIN BODY ECU (Click here)  

2.INSPECT DOOR CONTROL SWITCH ASSEMBLY
  1. Inspect the door control switch assembly (Click here).



NG
REPLACE DOOR CONTROL SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (DOOR CONTROL SWITCH ASSEMBLY - MAIN BODY ECU AND BODY GROUND)
  1. Disconnect the F22 door control switch assembly connector.

  1. Disconnect the D143 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F22-2 (UL) - D143-10 (UL1)
    Always
    Below 1 Ω
    F22-4 (L) - D143-9 (L1)
    Always
    Below 1 Ω
    F22-3 (E) - Body ground
    Always
    Below 1 Ω
    F22-2 (UL) - Body ground
    Always
    10 kΩ or higher
    F22-4 (L) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (Click here)