POWER DOOR LOCK CONTROL SYSTEM (for Sedan) > Only Passenger Door LOCK / UNLOCK Functions do not Operate |

| 1.INSPECT FRONT DOOR LOCK ASSEMBLY RH |
![]() |
Apply the battery voltage to the door lock motor and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery position (+) → Terminal 4 Battery negative (-) → Terminal 1 | Lock |
| Battery position (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlock |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - FRONT DOOR LOCK ASSEMBLY RH) |
![]() |
Disconnect the 4H main body ECU connector.
Disconnect the F5 door lock connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| 4H-8 (ACT+) - F5-4 (L) | Below 1 Ω |
| 4H-18 (ACT-) - F5-1 (UL) | Below 1 Ω |
Reconnect the main body ECU connectors.
Reconnect the door lock connector.
|
| ||||
| OK | ||
| ||