Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM (for Sedan)

AUTOMATIC TRANSAXLE SYSTEM (for Sedan) > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.
  1. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Refer to the Customer Problem Analysis (Click here).


    NEXT


    3.CONNECT TECHSTREAM TO DLC3*

      NEXT


      4.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
      1. Refer to the DTC Check/Clear (Click here).


      NEXT


      5.VISUAL INSPECTION

        NEXT


        6.SETTING CHECK MODE DIAGNOSIS*
        1. Refer to the Check Mode Procedure (Click here).


        NEXT


        7.PROBLEM SYMPTOM CONFIRMATION
        1. Refer to the Road Test (Click here).
          Result 
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B



        B.
        GO TO STEP 9
        A


        8.SYMPTOM SIMULATION
        1. Refer to How to Proceed with Troubleshooting (Click here).


        NEXT


        9.DTC CHECK*
        1. Refer to DTC Check/Clear (Click here).
          Result 
          Result
          Proceed to
          DTC not output
          A
          DTC output
          B



        B.
        GO TO STEP 17
        A


        10.BASIC INSPECTION
        1. Refer to Automatic Transaxle Fluid (Click here).

        2. Refer to Park/neutral Position Switch (Click here).

        3. Refer to Shift Lever Assembly (Click here).



        NG.
        GO TO STEP 19
        OK


        11.MECHANICAL SYSTEM TEST*
        1. Refer to the Mechanical System Test (Click here).



        NG.
        GO TO STEP 16
        OK


        12.HYDRAULIC TEST*
        1. Refer to the Hydraulic Test (Click here).



        NG.
        GO TO STEP 16
        OK


        13.MANUAL SHIFTING TEST
        1. Refer to the Manual Shifting Test (Click here).



        NG.
        GO TO STEP 15
        OK


        14.PROBLEM SYMPTOMS TABLE CHAPTER 1
        1. Refer to the Problem Symptoms Table (Click here).



        NG.
        GO TO STEP 18
        OK


        15.PROBLEM SYMPTOMS TABLE CHAPTER 2
        1. Refer to the Problem Symptoms Table (Click here).


        NEXT


        16.PART INSPECTION

          NEXT

          GO TO STEP 19


          17.DTC CHART
          1. Refer to the Diagnostic Trouble Code Chart (Click here).


          NEXT


          18.CIRCUIT INSPECTION

            NEXT


            19.REPAIR OR REPLACE

              NEXT


              20.CONFIRMATION TEST

                NEXT

                END