AUTOMATIC TRANSAXLE SYSTEM (for Hatchback) > MECHANICAL SYSTEM TESTS |
| STALL SPEED TEST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data.
Run the vehicle until the ATF (Automatic Transmission Fluid) temperature reaches 50 to 80°C (122 to 176°F).
Allow the engine to idle with the air conditioning off.
Chock all 4 wheels.
Set the parking brake and keep the brake pedal firmly depressed with your left foot.
Move the shift lever to D.
Depress the accelerator pedal all the way down with your right foot.
Read the engine speed (stall speed) and release the accelerator pedal immediately.
| Test Result | Possible Cause |
| Stall speed is lower than standard value |
|
| Stall speed is higher than standard value |
|
| SHIFT TIME LAG TEST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data.
Run the vehicle until the ATF (Automatic Transmission Fluid) temperature reaches 50 to 80°C (122 to 176°F).
Allow the engine to idle with the air conditioning off.
Set the parking brake and keep the brake pedal firmly depressed with your left foot.
Check the D position time lag.
Move the shift lever to N and wait for 1 minute.
move the shift lever to D and measure the time until the shock is felt.
Repeat the 2 steps above 3 times, and calculate the average time of the 3 tests.
Check the R position time lag.
Move the shift lever to N and wait for 1 minute.
Move the shift lever to R and measure the time until the shock is felt.
Repeat the 2 steps above 3 times, and calculate the average time of the 3 tests.
| Test Result | Possible Cause |
| D position time lag exceeds standard value |
|
| R position time lag exceeds standard value |
|