DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0711 | One of the following conditions (A), (B), (C), (D) or (E) is met: |
|
| Condition (A): (except Mexico Models) (a), (b), (c) and (d) are detected: (2 trip detection logic). (a) After normal driving for 10 minutes and 5 km (3.1 miles) or more. (b) Intake air and engine coolant temperature are 15°C (59°F) or more at engine start. (c) Soak time is 5 hours or more. (d) ATF temperature is less than 20°C (68°F) | ||
| Condition (B): (a), (b) and (c) are detected: (2 trip detection logic). (a) After normal driving for 18 minutes and 20 seconds and 9 km (5.6 miles) or more. (b) Intake air and engine coolant temperature are -10°C (14°F) or more at engine start. (c) ATF temperature is less than 20°C (68°F) | ||
| Condition (C): (a), (b) and (c) are detected: (2 trip detection logic). (a) After normal driving for 30 minutes and 15 km (9.3 miles) or more. (b) Intake air and engine coolant temperature are -15°C (5°F) or more at engine start. (c) ATF temperature is less than 20°C (68°F) | ||
| Condition (D): Both (a) and (b) are detected: (2 trip detection logic). (a) After normal driving for 40 minutes and 20 km (12.4 miles) or more. (b) ATF temperature is less than 20°C (68°F) | ||
| Condition (E): Both (a) and (b) are detected: (2 trip detection logic). (a) Engine coolant temperature is less than 35°C (95°F) at 12 seconds after engine start. (b) ATF temperature is 100°C (212°F) or more. |
| Related DTCs | P0711: ATF temperature sensor/Rationality check |
| Required sensors/Components | ATF temperature sensor |
| Frequency of operation | Continuous |
| Duration | Condition (A), (B), (C), and (D): 3 seconds Condition (E): Continuous |
| MIL operation | 2 driving cycles |
| Sequence of operation | None |
| Transmission Fluid Temperature Sensor "A" circuit | No circuit malfunction (P0712, P0713) |
| ECT sensor circuit | No circuit malfunction (P0115, P0117, P0118) |
| IAT sensor circuit | No circuit malfunction (P0110, P0112, P0113) |
| Electronic Throttle Control System | No circuit malfunction (P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P0607, P060A, P060B, P060D, P060E, P0657, P1607, P2102, P2103, P2111, P2112, P2118, P2119, P2135) |
| Soak Timer circuit | No circuit malfunction (P2610) |
| Time after engine start except for condition shift position N or P*1 | 10 minutes or more |
| Accumulated driving time*2 | 1 minute and 40 seconds or more |
| Driving distance after engine start*3 | 5 km (3.1 miles) or more |
| IAT*4 | 15°C (59°F) or more |
| ECT (12 seconds after engine start) | 15°C (59°F) or more |
| Soak time | 5 hours or more |
| Time after engine start except for condition shift position N or P*1 | 18 minutes and 20 seconds or more |
| Accumulated driving time*2 | 4 minutes and 10 seconds or more |
| Driving distance after engine start*3 | 9 km (5.6 miles) or more |
| IAT*4 | -10°C (50°F) or more |
| ECT (12 seconds after engine start) | -10°C (50°F) or more |
| Time after engine start except for condition shift position N or P*1 | 30 minutes or more |
| Accumulated driving time*2 | 6 minutes and 20 seconds or more |
| Driving distance after engine start*3 | 15 km (9.3 miles) or more |
| IAT*4 | -15°C (5°F) or more |
| ECT (12 seconds after engine start) | -15°C (5°F) or more |
| Time after engine start except for condition shift position N or P*1 | 40 minutes or more |
| Accumulated driving time*2 | 9 minutes and 10 seconds or more |
| Driving distance after engine start*3 | 20 km (12.4 miles) or more |
| Time after ECT reaches 60°C (140°F) | 10 seconds or more |
| Transmission fluid temperature (12 seconds after engine start) | 100°C (212°F) or more |
| ECT (12 seconds after engine start) | Less than 35°C (95°F) |
| Duration time from shifting to N or P | 300 seconds or more |
| Engine speed - Input (Turbine) speed | 50 rpm or more |
| Output speed | 400 rpm or more |
| Throttle valve opening angle | 3% or more |
| Shift position | Not "N" or "P" |
| Engine speed | 300 rpm or more |
| Duration time from shifting to N or P | 300 seconds or more |
| 12 seconds after engine start | |
| Duration time from shifting to N or P | 300 seconds or more |
| ATF temperature | Less than 20°C (68°F) |
| ATF temperature | 100°C (212°F) or more |
| ATF temperature sensor | Atmospheric temperature to approximately 130°C (266°F) |
| READ DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data.
In accordance with the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A/T Oil Temperature 1 | ATF Temperature Sensor Value/ Min.: -40°C (-40°F) Max.: 215°C (419°F) |
| If the value is "-40°C (-40°F)" or "150°C (302°F) or more", ATF temperature sensor circuit is opened or shorted. |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or more | Short circuit |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs using the Techstream.
| Result | Proceed to |
| Only DTC P0711 is output | A |
| P0711 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
Check the transmission fluid level (Click here).
|
| ||||
| OK | ||
| ||