Home › Engine / Hybrid System › 1NZ-FE STARTING › IGNITION SWITCH (for Sedan)

IGNITION SWITCH (for Sedan) > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY


A119192E01
  1. Engage the 2 claws and install the ignition or starter switch assembly.

  1. Connect the connector.



2. INSTALL STEERING COLUMN COVER


E107139
  1. Install the screw indicated in the illustration.



    A119195
  1. Turn the steering wheel to the left and install the screw indicated in the illustration.



    E107137
  1. Turn the steering wheel to the right, and install the screw indicated in the illustration.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }