Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER (for Sedan)

CONDENSER (for Sedan) > REASSEMBLY



1. INSTALL COOLER DRYER


    E101933
  1. Using pliers, install the cooler dryer into the modulator.



    E101932
  1. Apply sufficient compressor oil to a new O-ring and the fitting surface of the cap.

    Compressor oil:
    ND-OIL 8 or the equivalent



    E101931E03
  1. Using a 14 mm straight hexagon wrench, install the cap onto the modulator.

    Torque:
    2.9 N*m{ 30 kgf*cm , 25 in.*lbf }