SEAT BELT WARNING SYSTEM (for Sedan) > TERMINALS OF ECU |
| COMBINATION METER ASSEMBLY |

Disconnect the D1 combination meter assembly connector.
Measure the voltage and resistance of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| D1-1 - Body ground | B - Body ground | Ignition switch signal | Ignition switch OFF → ON | Below 1 V → 11 to 14 V |
| D1-2 - Body ground | L - Body ground | Battery | Always | 11 to 14 V |
| D1-24 - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
Reconnect the D1 combination meter assembly connector.
Measure the voltage of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| D1-20 - Body ground | G - Body ground | CAN communication line | Ignition switch ON | Pulse generation |
| D1-21 - Body ground | W - Body ground | CAN communication line | Ignition switch ON | Pulse generation |
| D76-9 - Body ground | BE - Body ground | Seat belt warning light signal (Front passenger side) | Ignition switch ON Front passenger seat is occupied and its seat belt is unfastened | Alternating between 11 to 14 V and below 1 V |
| D76-9 - Body ground | BE - Body ground | Seat belt warning light signal (Front passenger side) | Ignition switch ON Front passenger seat is occupied and its seat belt is fastened | Below 1 V |
| CENTER AIRBAG SENSOR ASSEMBLY |

| Terminal No. | Terminal Symbol | Destination |
| D16-13 | CANH | CAN communication line |
| D16-21 | IG2 | IGN fuse |
| D16-22 | CANL | CAN communication line |
| D16-25 | E1 | Ground |
| D16-26 | E2 | Ground |
| J8-11 | DBE+ | Front seat inner belt assembly LH |
| J8-12 | DBE- | Front seat inner belt assembly LH |
| J9-12 | FSP+ | Occupant Classification ECU |
| J9-13 | FSP- | Occupant Classification ECU |
| OCCUPANT CLASSIFICATION ECU |

Disconnect the J24 occupant classification ECU connector.
Measure the voltage and resistance of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| J24-7 (IG) - J24-3 (GND) | BE - W-B | Power source (IG2 Fuse) | Ignition switch OFF | Below 1 V |
| J24-7 (IG) - J24-3 (GND) | BE - W-B | Power source (IG2 Fuse) | Ignition switch ON | 11 to 14 V |
| J24-1 (+B) - Body ground | V - Body ground | Power source (ECU-B Fuse) | Always | 11 to 14 V |
| J24-3 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the J24 occupant classification ECU connector.
Measure the voltage of the connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| J24-9 (BSW) - J24-5 (BGND) | BE - P | Passenger side buckle switch line | Buckle switch ON Buckle switch OFF | Pulse generation |
| J24-8 (FSR+) - J24-4 (FSR-) | GR - Y | Center airbag sensor assembly communication line | Ignition switch ON | Pulse generation |