FRONT EVAPORATOR TEMPERATURE SENSOR (for Hatchback) > INSTALLATION |
| 1. INSTALL FRONT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR) |
![]() |
Install the front evaporator temperature sensor (No. 1 cooler thermistor) as shown in the illustration.
| Mark | Measurement |
| a | 34.3 mm (1.35 in.) |
| b | 20.9 mm (0.82 in.) |
| c | 48 to 52 mm (1.890 to 2.047 in.) |
| *1 | from Tank |
| *2 | Fixed Part |
| *3 | Sensor Part |
| *4 | Next to Previous |
| *5 | Plastic Case |
| *6 | Evaporator |
| 2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Install the cooler evaporator with the cooler thermistor.
![]() |
Engage the 4 claws and install the lower heater case.
Install the 3 screws.
![]() |
Engage the clamp and install the connector to the lower heater case.
| 3. INSTALL COOLER EXPANSION VALVE |
![]() |
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the No. 1 cooler evaporator.
Install the 2 O-rings to the cooler evaporator.
Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.
| 4. INSTALL NO. 2 AIR DUCT |
Engage the 3 claws and install the air duct.
| 5. INSTALL NO. 1 AIR DUCT |
Engage the 3 claws and install the air duct.
| 6. INSTALL AIR CONDITIONER UNIT ASSEMBLY |