Home › Engine / Hybrid System › 1NZ-FE STARTING › IGNITION SWITCH (for Hatchback)

IGNITION SWITCH (for Hatchback) > INSPECTION



1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


    A247262E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      Between all terminals
      LOCK
      10 kΩ or higher
      2 (ACC) - 4 (AM1)
      ACC
      Below 1 Ω
      1 (IG1) - 2 (ACC) - 4 (AM1)
      ON
      Below 1 Ω
      5 (AM2) - 6 (IG2)
      1 (IG1) - 4 (AM1)
      START
      Below 1 Ω
      5 (AM2) - 6 (IG2) - 7 (ST2)

      If the result is not as specified, replace the ignition or starter switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Ignition or Starter Switch Assembly)
      *b
      LOCK
      *c
      ACC
      *d
      ON
      *e
      START