Home›Vehicle Interior›SUPPLEMENTAL RESTRAINT SYSTEMS›AIRBAG SYSTEM (for Hatchback without VSC)
AIRBAG SYSTEM (for Hatchback without VSC) > CHECK MODE PROCEDURE
CHECK MODE (SIGNAL CHECK): DTC CHECK
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Select Signal Check, and proceed with checking using the Techstream.
NOTICE:
Select Signal Check from the DTC Check screen displayed on the Techstream to clear the output DTCs (both present and past).
HINT:
DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
Perform the check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through the normal diagnosis mode inspection.