METER / GAUGE SYSTEM (for Sedan) > Driver Side Seat Belt Warning Light does not Operate |

| 1.CHECK SUPPLEMENTAL RESTRAINT SYSTEM |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.
| Result | Proceed to |
| No SRS DTCs are output | A |
| SRS DTCs are output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (D-BELT REMIND) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Driver Side Seat Belt | Driver side seat belt warning light | OFF/ON | Vehicle is stopped and engine is idling |
|
| ||||
| NG | ||
| ||