Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM (for Sedan)

SEAT BELT WARNING SYSTEM (for Sedan) > Driver Side Seat Belt Warning Light does not Operate


DESCRIPTION

  1. When the ignition switch is ON, the center airbag sensor assembly communicates the status of the front seat inner belt assembly LH to the main body ECU using the CAN communication line. The main body ECU receives signals from the center airbag sensor assembly and transmits them to the combination meter assembly. When the seat belt is unfastened, the combination meter assembly flashes the driver seat belt warning light in the combination meter assembly. When the seat belt is fastened, the combination meter assembly stops flashing the front driver seat belt warning light.

WIRING DIAGRAM


B119959E01


INSPECTION PROCEDURE

1.CHECK SUPPLEMENTAL RESTRAINT SYSTEM
  1. Check for DTCs.

    Result:
    Result
    Proceed to
    No SRS DTCs are output
    A
    SRS DTCs are output
    B



B
GO TO SUPPLEMENTAL RESTRAINT SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (D-BELT REMIND)
  1. Operate a Techstream according to the steps on the display and select "Active Test".

    Combination Meter Assembly:

    Item
    Test Details
    Diagnostic Note
    Driver Side Seat Belt
    Front driver seat belt warning light / OFF or ON
    -

    OK:
    Front driver seat belt warning light comes on.



OK
REPLACE MAIN BODY ECU
NG

REPLACE COMBINATION METER ASSEMBLY (Click here)