FUEL SENDER GAUGE ASSEMBLY (for Sedan) > INSPECTION |
| 1. INSPECT FUEL SENDER GAUGE ASSEMBLY |
![]() |
Check the fuel sender gauge resistance (Fuel sender gauge Type A).
Check that the float moves smoothly between the F level (upper end) and E level (lower end).
Using an ohmmeter, measure the resistance between connector terminals 2 (FS) and 1 (FE) at the upper and lower ends of the float. Check that the resistance varies uniformly.
| Float Level | Resistance (Ω) |
| F (Upper End) | 12.0 to 18.0 |
| E (Lower End) | 405.0 to 415.0 |
![]() |
Check the fuel sender gauge resistance (Fuel sender gauge Type B).
Check that the float moves smoothly between the F level (upper end) and E level (lower end).
Using an ohmmeter, measure the resistance between connector terminals 2 (FS) and 1 (FE) at the upper and lower ends of the float. Check that the resistance varies uniformly.
| Float Level | Resistance (Ω) |
| F (Upper End) | 13.5 to 16.5 |
| E (Lower End) | 405.5 to 414.5 |