CONDENSER (for Sedan) > REMOVAL |
| 1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
Switch A/C ON.
Turn the blower switch to ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.
Stop the engine.
![]() |
Remove the caps from the service valves on the refrigerant line.
Connect the refrigerant recovery unit.
Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.
| 2. REMOVE FRONT BUMPER COVER |
| 3. REMOVE NO. 1 COOLER COVER |
![]() |
Remove the 2 clips and No. 1 cooler cover.
| 4. SEPARATE HOOD LOCK ASSEMBLY (w/ Theft Deterrent System) |
![]() |
Separate the hood lock control cable assembly from the 2 clamps.
![]() |
Separate the engine hood courtesy switch connector.
Remove the 3 bolts and remove the hood lock assembly.
| 5. SEPARATE HOOD LOCK ASSEMBLY (w/o Theft Deterrent System) |
![]() |
Separate the hood lock control cable assembly from the 2 clamps.
![]() |
Remove the 3 bolts and remove the hood lock assembly.
| 6. REMOVE RADIATOR SUPPORT SUB-ASSEMBLY UPPER |
![]() |
Separate the horn assembly connector.
Remove the 4 bolts and remove the radiator support sub-assembly upper.
| 7. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() |
Remove the bolt and disconnect the discharge hose from the cooler condenser.
Remove the O-ring from the discharge hose.
| 8. DISCONNECT LIQUID TUBE SUB-ASSEMBLY A |
![]() |
Remove the bolt and disconnect the liquid tube from the cooler condenser.
Remove the O-ring from the liquid tube.
| 9. REMOVE CONDENSER |
![]() |
Disengage the 2 claws and remove the condenser from the vehicle.