HOOD LOCK CONTROL CABLE ASSEMBLY (for Sedan) > INSTALLATION |
| 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY |
Pass the hood lock control cable assembly into the engine compartment.
Pass the cable through the upper radiator support.
Connect the clamps as shown in the illustration.
| 2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
Install the hood lock control lever sub-assembly and connect the hood lock control cable.
| 3. INSTALL HOOD LOCK ASSEMBLY |
![]() |
Apply MP grease to the sliding areas of the lock.
Connect the hood lock control cable.
Install the hood lock assembly with the 3 bolts.
Connect the connector and clamp.
| 4. INSPECT HOOD SUB-ASSEMBLY |
Check that the clearance measurements are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 2.35 to 6.35 mm (0.092 to 0.250 in.) | C | 2.0 to 5.0 mm (0.079 to 0.197 in.) |
| B | -2 to 2 mm (-0.079 to 0.079 in.) | - | - |
| 5. ADJUST HOOD SUB-ASSEMBLY |
![]() |
Loosen the hood side hinge bolts.
Move the hood to adjust the clearance to within the standard range.
Tighten the hood side hinge bolts after the adjustment.
![]() |
Adjust the height of the hood front end by turning the cushion rubber.
![]() |
Adjust the hood lock.
Loosen the 3 bolts.
Adjust the hood lock position so that the striker can enter it smoothly.
Tighten the 3 bolts after the adjustment.
| 6. INSTALL FRONT FENDER LINER LH |
Install the front fender liner LH with the 7 clips.
Install the 4 new grommets.
Install the 7 screws.
| 7. INSTALL FRONT WHEEL |