Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY (for Sedan)

HOOD LOCK CONTROL CABLE ASSEMBLY (for Sedan) > REMOVAL



1. REMOVE FRONT WHEEL


2. REMOVE FRONT FENDER LINER LH


    B178169
  1. Remove the 7 screws.

  1. Remove the 4 grommets.

    HINT:
    The grommet needs to be replaced with a new one because it will break when it is removed.

  1. Remove the 7 clips and remove the front fender liner LH.



3. REMOVE HOOD LOCK ASSEMBLY


    B178170
  1. Disconnect the connector and clamp.

  1. Remove the 3 bolts and remove the hood lock assembly.



    B178171
  1. Disconnect the hood lock control cable.



4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B178172
  1. Disconnect the hood lock control cable and remove the hood lock control lever.



5. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Using a screwdriver with its tip wrapped in protective tape, disconnect the clamps shown in the illustration.


    B178174E01


    Area
    Part Name
    A
    Hood lock control cable
    B
    Clamp
    C
    Hood cable grommet
    D
    Air cleaner

  1. Pull the cable from the engine compartment and remove it.