THEFT DETERRENT SYSTEM (for Hatchback) > ECU Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY, BODY GROUND) |
![]() |
Disconnect the 3C, 3E and 3B instrument panel junction block assembly connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3B-8 - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| 3C-21 - Body ground | Always | 11 to 14 V |
| 3E-1 - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | |
| 2.CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (POWER SOURCE, BODY GROUND) |
Reconnect the 3B, 3C, and 3E instrument panel junction block assembly connectors.
Remove the main body ECU (Click here).

| *a | instrument panel junction block assembly | - | - |
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| MB-30 (BECU) - Body ground | Always | 11 to 14 V |
| MB-31 (ALTB) - Body ground | Always | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| MB-11 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||