CLUTCH SYSTEM (for Hatchback) > BLEEDING |
| 1. REMOVE CENTER COWL TOP VENTILATOR LOUVER |
![]() |
Disengage the 2 clips and slide the hood to cowl top seal as shown in the illustration.
![]() |
Disengage the 2 claws and separate the washer hose joint.
Disengage the 2 claws and 6 guides remove the cowl top ventilator louver center.
| 2. FILL RESERVOIR WITH BRAKE FLUID |
![]() |
Fill the reservoir with brake fluid.
| *a | MAX Line |
| *b | MIN Line |
| 3. BLEED CLUTCH LINE |
![]() |
Remove the release cylinder bleeder plug cap.
| *1 | Release Cylinder Bleeder Plug Cap |
| *2 | Release Cylinder Bleeder Plug |
Connect a vinyl tube to the release cylinder bleeder plug.
Depress the clutch pedal 5 times, and then loosen the release cylinder bleeder plug while the pedal is depressed.
When fluid no longer comes out, tighten the release cylinder bleeder plug, and then release the clutch pedal.
Repeat both of the previous 2 steps 6 times.
Tighten the release cylinder bleeder plug.
Depress the clutch pedal 10 times or more and confirm its operation.
Install the release cylinder bleeder plug cap.
Check that all the air has been bled from the clutch line.
| 4. INSPECT FOR BRAKE FLUID LEAK |
| 5. INSPECT BRAKE FLUID LEVEL |
![]() |
Check the fluid level.
| *a | MAX Line |
| *b | MIN Line |
| 6. INSTALL CENTER COWL TOP VENTILATOR LOUVER |
![]() |
Engage the 2 claws and 6 guides and install the cowl top ventilator louver center.
Engage the 2 claws and install the washer hose joint.
![]() |
Engage the 2 clips and slide the hood to cowl top seal as shown in the illustration.