Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU (for Hatchback)

OCCUPANT CLASSIFICATION ECU (for Hatchback) > INSTALLATION


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL OCCUPANT DETECTION ECU


    B288381
  1. Engage the claw to install the occupant detection ECU.

    NOTICE:
    If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.

  1. Connect the 2 connectors.

    NOTICE:
    When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.



2. INSTALL FRONT SEAT ASSEMBLY RH
(Click here)


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)