Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU (for Hatchback)

OCCUPANT CLASSIFICATION ECU (for Hatchback) > REMOVAL



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).

NOTICE:
  1. When removing front seat assembly RH, perform zero point calibration and sensitivity check (Click here).
  2. When replacing the occupant detection ECU, perform zero point calibration and sensitivity check (Click here).



2. REMOVE FRONT SEAT ASSEMBLY RH
(Click here)


3. REMOVE OCCUPANT DETECTION ECU


    B288382
  1. Disconnect the 2 connectors.



    B290683E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the claw and remove the occupant detection ECU.
    Text in Illustration 
    *1
    Protective Tape