LIGHTING SYSTEM (for Sedan) > IG Signal Circuit |

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG SW | Ignition switch signal/ ON or OFF | ON: Ignition switch ON OFF: Ignition switch ACC or off | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY, IGNITION SWITCH AND BODY GROUND) |
![]() |
Disconnect the 4E, 4F, 4G and 4M main body ECU connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4G-1 - Body ground | Always | 11 to 14 V |
| 4F-3 - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4E-17 - Body ground | Always | Below 1 Ω |
| 4M-7 - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Main Body ECU) |
|
| ||||
| OK | ||
| ||