Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SEAT POSITION SENSOR (for Sedan)

SEAT POSITION SENSOR (for Sedan) > REMOVAL


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

NOTICE:
Always use "Torx" socket wrench E10 when removing the front seat.

HINT:
Installation is in the reverse order of removal.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT SEAT HEADREST ASSEMBLY


    B138314E02
  1. Push in the lock button of the front seat headrest support and remove the front seat headrest.
    Text in Illustration 
    *1
    Lock Button



3. REMOVE FRONT SEAT ASSEMBLY LH


    B209187
  1. Disconnect the buckle switch connector.



    B138317
  1. Move the front seat to its most rearward position.

  1. Using an E10 "TORX" socket wrench, remove the 2 bolts from the front side.

  1. Move the front seat to its most forward position.

  1. Using an E10 "TORX" socket wrench, remove the 2 bolts from the rear side.

  1. Remove the front seat.



4. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR
  1. Remove the seat slide position sensor protector from the seat position airbag sensor.



5. REMOVE SEAT POSITION AIRBAG SENSOR


    C121540E01
  1. Disconnect the connector from the seat position airbag sensor.

  1. Using "Torx" socket wrench T30, remove the torx screw and the seat position airbag sensor.