Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU (for Sedan)

OCCUPANT CLASSIFICATION ECU (for Sedan) > REMOVAL


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

NOTICE:
Installation is in the reverse order of removal.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT SEAT HEADREST ASSEMBLY


    B138314E02
  1. Push in the lock button of the front seat headrest support and remove the front seat headrest.
    Text in Illustration 
    *1
    Lock Button



3. REMOVE FRONT SEAT ASSEMBLY RH


    B332565
  1. Using a clip remover, remove the clamp.

  1. Disconnect the buckle switch connector.

  1. Disconnect the occupant detection ECU connector.



    B209185
  1. Move the front seat to its most rearward position.

  1. Using an E10 "TORX" socket wrench, remove the 2 bolts from the front side.

  1. Move the front seat to its most forward position.

  1. Using an E10 "TORX" socket wrench, remove the 2 bolts from the rear side.

  1. Remove the front seat.



4. REMOVE OCCUPANT CLASSIFICATION ECU


    C121541E01
  1. Disconnect the connectors from the occupant classification ECU.

  1. Using a screwdriver, remove the occupant classification ECU.