ENGINE IMMOBILISER SYSTEM (for Sedan) > DTC CHECK / CLEAR |
| CHECK DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.
Read the DTCs.
| CHECK FOR ECM DTC |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| CLEAR DTC |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.
Erase the DTCs.
| CLEAR FOR ECM DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Erase the DTCs.