Component
| Function
|
Door control transmitter module set sub-assembly
| - Has lock, unlock, and panic switches.
- Transmits weak radio waves (recognition codes and function codes) to the door control receiver.
- Illuminates the indicator light (LED) during transmission.*2
|
Door control receiver
| Receives weak radio waves from the door control transmitter module set sub-assembly and sends them to the main body ECU.
|
- Front door courtesy light switch assembly LH/RH
- Rear door courtesy light switch assembly LH/RH*1
- Back door courtesy switch
| - Turns on when a door is opened and turns off when it is closed.
- Outputs door status signals (open or closed) to the main body ECU.
|
Unlock warning switch assembly
| Detects if the key is inserted in the ignition key cylinder or not.
|
- Front door lock assembly LH/RH
- Rear door lock assembly LH/RH*1
| - Built in motor locks or unlocks door.
- Transmits the door lock position of each door to the main body ECU.
|
Main body ECU
| Sends wireless door lock control signals in response to the code data from the door control receiver and signals from each switch.
|
Function
| Operation
|
All door lock
| Pressing the lock switch locks all doors.
|
All door unlock (Unlock 2 operation)
| Pressing the unlock switch twice within 3 seconds unlocks all the doors after the driver door is unlocked.
|
Automatic lock
| If none of the doors is opened within 60 seconds after they are unlocked by wireless door lock control, all the doors will lock again automatically.
|
Answer back
| - When the doors are locked by wireless operation, the hazard warning lights flash once.
- When the doors are unlocked by wireless operation, the hazard warning lights flash twice.
|
Panic alarm
| Pressing the panic switch of the door control transmitter module set sub-assembly for longer than about 0.8 seconds causes the following alarms to activate:
- Sound the vehicle horn.
- Sound the security horn.*1
- Blinks the headlights, hazard warning lights and taillights.
- Illuminates the interior lights (when the switch is in the door position).
While the panic alarm is operating, pressing any switch of the door control transmitter module set sub-assembly cancels the alarm operation.
|
Illuminated entry
| When all the doors are locked, pressing the unlock switch causes the interior lights to come on simultaneously with the unlock operation.
|
Self-diagnostic mode
| The following are conditions to enter self-diagnostic mode:
- If the door control receiver receives normal radio waves from the door control transmitter module set sub-assembly when the system is in diagnostic mode, it flashes the interior lights in a normal pattern that corresponds to the function of each switch.
|
Transmitter recognition code registration
| Enables registration (writing and storing) of door control transmitter module set sub-assembly recognition codes in the EEPROM that is contained in the door control receiver.
|