WIRELESS DOOR LOCK CONTROL SYSTEM (for Sedan) > DTC CHECK / CLEAR |
| DTC CHECK |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Enter the following menu: Body Electrical / Main Body / Trouble Codes.
Check DTCs.
Confirm the details of the DTCs
| DTC CLEAR |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Enter the following menu: Body Electrical / Main Body / Trouble Codes.
Erase DTCs.
| SELF-DIAGNOSTIC MODE (OPERATING IGNITION KEY CYLINDER) |
Switch to self-diagnostic mode.
Establish the vehicle's initial condition.
Insert the key into the ignition key cylinder and remove it.
Within 5 seconds of removing the key, insert it into the ignition key cylinder again.
Turn the ignition switch ON and then OFF.
Within 30 seconds of turning the ignition switch OFF, perform the following operation 9 more times: Turn the ignition switch ON and then OFF.
![]() |
Check that the system has switched to self-diagnostic mode by checking the flash pattern of the interior light.
Check the diagnostic outputs when the door control transmitter switch is held down. The diagnostic outputs can be checked by the flash patterns of the interior light.

| SELF-DIAGNOSTIC MODE (USING TECHSTREAM) |
Switch to self-diagnostic mode.
Connect a Techstream to the DLC3.
Turn the ignition switch to ON and turn the tester on.