THEFT DETERRENT SYSTEM (for Sedan) > TERMINALS OF ECU |
| CHECK THEFT WARNING ECU ASSEMBLY (THEFT DETERRENT ECU) |

Disconnect the D26 ECU connector.
Check the voltage or resistance of each terminal of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| +B1 (D26-11) - Body ground | B - Body ground | Battery | Always | 11 to 14 V |
| +B2 (D26-13) - Body ground | BR - Body ground | Battery | Always | 11 to 14 V |
| IG (D26-9) - E (D26-16) | GR - W-B | Ignition switch signal | Ignition switch OFF → ON | Below 1 V → 11 to 14 V |
| LUG (D26-6) - Body ground | P - Body ground | Luggage compartment door unlock detection switch signal | Luggage compartment door LOCK → UNLOCK | 10 kΩ or higher → Below 1 Ω |
| E (D26-16) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the D26 ECU connector.
Check the voltages of each terminal of the connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| BRK+ (D26-24) - Body ground | P - Body ground | Alarm BERKES Communication | Theft deterrent system is in alarm sounding state. | Pulse generation (1.5 V ← → Below 1.2 V) |
| BRK- (D26-25) - Body ground | BE - Body ground | Alarm BERKES Communication | All doors are locked using key (Theft deterrent system is in arming preparation state). | Pulse generation (1.5 V ← → Below 1.2 V) |
| SH- (D26-15) - Body ground | BE - Body ground | Security horn | Security horn is sounding (Theft deterrent system is in alarm sounding state). | Pulse generation (11 to 14 V ← → Below 1 V) |
| +B1 (D26-11) - E (D26-16) | B - W-B | +B power supply | Always | 11 to 14 V |
| KSW (D26-7) - E (D26-16) | Y - W-B | Key unlock warning switch input | Key unlock warning switch ON (Key inserted) → OFF (Key removed from ignition key cylinder) | Below 1 V → 11 to 14 V |
| IND (D26-29) - E (D26-16) | G - W-B | Security indicator | Security indicator lights up (illuminates for 30 seconds in alarm sounding state, flashes when immobiliser system is operating). | 5 V or more |
| DSWH (D26-4) - E (D26-16) | W - W-B | Engine hood courtesy switch input | Engine hood courtesy switch OFF (Closed) → ON (Open) | 11 to 14 V → Below 1 V |