Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (for Hatchback)

THEFT DETERRENT SYSTEM (for Hatchback) > Unlock Warning Switch Circuit


DESCRIPTION

The key unlock warning switch assembly comes on when the ignition key is inserted into the ignition key cylinder and goes off when the ignition key is removed.

WIRING DIAGRAM


B291333E02


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. According to the display on the Techstream, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Unlock Warning SW
    Unlock warning switch / OFF or ON
    OFF: Key is removed from ignition key cylinder
    ON: Key is inserted into ignition key cylinder
    -

    OK:
    When the key is in the ignition key cylinder, "ON" appears on the screen.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY
  1. Inspect the unlock warning switch assembly (Click here).



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - UNLOCK WARNING SWITCH ASSEMBLY - BODY GROUND)
  1. Disconnect the D143 main body ECU connector.

  1. Disconnect the D111 unlock warning switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D143-17 (KSW) - D111-2
    Always
    Below 1 Ω
    D143-17 (KSW) - Body ground
    Always
    10 kΩ or higher
    D111-1 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (Click here)