DTC B1787 Rear Occupant Classification Sensor LH Collision Detection |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1787 | Either of following conditions is met:
| Separate type front seat cushion pad RH (Rear occupant classification sensor LH) |

| 1.PERFORM ZERO POINT CALIBRATION |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Using the Techstream, perform the zero point calibration (Click here).
|
| ||||
| OK | |
| 2.CHECK FOR DTC |
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear any DTCs stored in the memory (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Using the Techstream, check for DTCs of the occupant classification ECU (Click here).
| Result | Proceed to |
| NG | A |
| OK | B |
|
| ||||
| A | |
| 3.REPLACE SEPARATE TYPE FRONT SEAT CUSHION PAD RH |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Replace the separate type front seat cushion pad RH (Click here).
| NEXT | |
| 4.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Using the Techstream, perform Zero Point Calibration and Sensitivity Check (Click here).
| NEXT | ||
| ||