Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM (for Hatchback)

DTC    B1788    Rear Occupant Classification Sensor RH Collision Detection


DESCRIPTION

DTC B1788 is stored when the occupant classification ECU receives a collision detection signal, which is sent by the rear occupant classification sensor RH when an accident occurs.
DTC B1788 is also stored when the separate type front seat cushion spring assembly is subjected to a strong impact, even if an actual accident has not occurred.
However, when the occupant classification ECU outputs a collision detection signal, even if the vehicle is not in a collision, DTC B1788 can be cleared by conducting the zero point calibration and sensitivity check.
Therefore, if DTC B1788 is stored, first perform the zero point calibration and sensitivity check.

DTC Code
DTC Detection Condition
Trouble Area
B1788
Either of following conditions is met:
  1. Occupant classification ECU receives collision detection signal, which is sent by occupant classification sensor rear RH when accident occurs
  2. Separate type front seat cushion spring assembly is subjected to strong impact, even if actual accident has not occurred
Separate type front seat cushion pad RH (Rear occupant classification sensor RH)

HINT:
  1. When DTC B1650/32 is stored as a result of troubleshooting the airbag system, perform troubleshooting for DTC B1788 of the occupant classification system.
  2. Use the Techstream to check for DTCs of the occupant classification ECU, otherwise the DTCs cannot be read.


WIRING DIAGRAM


C243258E05


INSPECTION PROCEDURE

1.PERFORM ZERO POINT CALIBRATION
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Using the Techstream, perform the zero point calibration (Click here).



NG
Go to step 3
OK


2.CHECK FOR DTC
  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear any DTCs stored in the memory (Click here).

    HINT:
    1. First clear DTCs stored in the occupant classification ECU and then in the airbag sensor assembly.
    2. Use the Techstream to clear the DTCs of the occupant classification ECU, otherwise the DTCs cannot be cleared.

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Using the Techstream, check for DTCs of the occupant classification ECU (Click here).

    OK:
    DTC B1788 is not output.

    HINT:
    DTCs other than DTC B1788 may be output at this time, but they are not related to this check.

    Result 
    Result
    Proceed to
    NG
    A
    OK
    B



B
END
A


3.REPLACE SEPARATE TYPE FRONT SEAT CUSHION PAD RH
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Replace the separate type front seat cushion pad RH (Click here).

    HINT:
    Perform the inspection using parts from a normal vehicle when possible.


NEXT


4.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Using the Techstream, perform Zero Point Calibration and Sensitivity Check (Click here).


NEXT

END