Home › Drivetrain ยท C50 MANUAL TRANSMISSION / TRANSAXLE › BACK-UP LIGHT SWITCH (for Hatchback)

BACK-UP LIGHT SWITCH (for Hatchback) > REMOVAL

for Preparation Click here



1. REMOVE AIR CLEANER CAP W/ AIR CLEANER HOSE


    A249575
  1. Disengage the clamp and disconnect the fuel vapor feed hose assembly from the No. 1 air cleaner hose.

  1. Loosen the 2 hose clamps and disconnect the fuel vapor feed hose assembly from the No. 1 air cleaner hose and vacuum switching valve assembly.



    A249576
  1. Disconnect the No. 2 fuel vapor feed hose from the intake manifold.



    A249577
  1. Disengage the 2 clamps and disconnect the wire harness from the air cleaner cap sub-assembly and vacuum switching valve assembly.

  1. Disconnect the mass air flow meter connector.

  1. Disconnect the vacuum switching valve connector.



    A249578
  1. Loosen the hose clamp and disconnect the No. 1 air cleaner hose from the throttle with motor body assembly.

  1. Disengage the 2 clamps and remove the air cleaner cap sub-assembly with No. 1 air cleaner hose.



    A246503
  1. Remove the air cleaner element.



    A249653
  1. Disengage the clamp and disconnect the wire harness from the air cleaner case.

  1. Remove the 2 bolts and the air cleaner case from the air cleaner bracket.



2. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


C235550E01
  1. Remove the clip A and washer, and then separate the control shift cable of transmission control cable assembly from the manual transaxle assembly.

  1. Remove the clip B and separate the control shift cable of transmission control cable assembly from the shift control cable bracket.



3. REMOVE BACK UP LIGHT SWITCH ASSEMBLY


C235551E01
  1. Separate the 2 clamps and disconnect the back up light switch assembly connector.

  1. Using SST, remove the back up light switch assembly from the manual transaxle assembly.

    SST
    09817-16011  

  1. Remove the gasket from the back up light switch assembly.