ENGINE IMMOBILISER SYSTEM (for Sedan) > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body Electrical / Immobiliser / Data List.
According to the display on tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key SW | Unlock warning switch signal/ ON or OFF | OFF: No key is in ignition key cylinder ON: Key is in ignition key cylinder | - |
| IG SW | Ignition switch signal/ ON or OFF | OFF: Ignition switch OFF or ACC ON: Ignition switch ON | - |
| Immobiliser | Immobiliser system status/ SET or UNSET | UNSET: Ignition switch ON SET: Without key | - |
| Permit (Start) | Start control system starting control / OK or NG | OK: Start control system starting is permitted NG: Start control system starting is not permitted | - |
| Response | Transponder chip data/ NG or OK | NG: Data error OK: Data OK | - |
| Frame Error | Transponder chip data/ NG or OK | NG: Data error OK: Data OK | - |
| Different Serial Number | Transponder chip data/ NG or OK | NG: Data error OK: Data OK | - |
| Different Encrypt Code | Transponder chip data/ NG or OK | NG: Data error OK: Data OK | - |
| Abnormal Status | Transponder chip data/ NG or OK | NG: Data error OK: Data OK | - |
| Bcc Malfunction | Transponder chip signal/ NG or OK | NG: Incorrect data sending OK: Correct data sending | - |
| Sub Key | Sub-key code signal/ NOMATCH or MATCH | NOMATCH: Unmatched sub-key code is sent MATCH: Matched sub-key code is sent | - |
| Master Key | Master key code signal/ NOMATCH or MATCH | NOMATCH: Unmatched master key code is sent MATCH: Matched master key code is sent | - |
| Transponder S-Code | Number of registered sub-keys/ min. 0, max. 15 | Number of registered sub-keys | - |
| Transponder M-Code | Number of registered master keys/ min. 0, max. 15 | Number of registered master keys | - |
| Reg Code Space Full | Memory space for key code registration/ NOT FUL or FULL | NOT FUL: Possible to register more key codes FULL: Cannot register any more key codes | - |
| +B | +B judgment / NORMAL or BREAK | NORMAL: Battery supply is normal BREAK: Battery supply is malfunctioning | - |
| Antenna Coil Status | Antenna coil condition/ NORMAL or FAIL | NORMAL: Antenna coil is normal FAIL: Antenna coil is malfunctioning | - |
| ACTIVE TEST |
Connect Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body Electrical / Immobiliser / Active Test.
According to the display on tester, perform the "Active Test".
| Tester Display | Test Part | Control Range |
| SECURITY INDIC | Turn security indicator ON/OFF | - |