Home
›
Drivetrain · C50 MANUAL TRANSMISSION / TRANSAXLE
›
BACK-UP LIGHT SWITCH (for Sedan)
BACK-UP LIGHT SWITCH (for Sedan) > INSPECTION
1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
Measure the resistance of the switch.
Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Pushed
Below 1 Ω
1 - 2
Released
10 kΩ or higher
If the result is not as specified, replace the back-up light switch assembly.