Home › Engine / Hybrid System › 1NZ-FE COOLING › RELAY (for Hatchback)

RELAY (for Hatchback) > ON-VEHICLE INSPECTION



1. INSPECT FAN NO. 1 RELAY


E209082
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage not applied
      10 kΩ or higher
      3 - 5
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      1. If the result is not as specified, replace the relay.



2. INSPECT FAN NO. 2 RELAY


A159206E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 4
      Battery voltage not applied
      Below 1 Ω
      3 - 4
      Battery voltage applied to terminals 1 and 2
      10 kΩ or higher
      3 - 5
      Battery voltage not applied
      10 kΩ or higher
      3 - 5
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      1. If the result is not as specified, replace the relay.