NAME PLATE (for Hatchback) > REMOVAL |
| 1. REMOVE SYMBOL EMBLEM |
![]() |
Apply protective tape to the back door panel in the area around the symbol emblem.
| *a | Wooden Blocks |
| *b | Protective Tape |
| *c | Location Pin |
Pass a piano wire between the back door panel and symbol emblem.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Pull the piano wire and scrape off the double-sided tape that holds the symbol emblem to the back door panel.
Remove the symbol emblem.
| 2. REMOVE NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE |
![]() |
Apply protective tape to the back door panel in the area around the No. 2 luggage compartment door name plate.
| *a | Wooden Blocks |
| *b | Protective Tape |
Pass a piano wire between the back door panel and No. 2 luggage compartment door name plate.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Pull the piano wire and scrape off the double-sided tape that holds the No. 2 luggage compartment door name plate to the back door panel.
Remove the No. 2 luggage compartment door name plate.
| 3. REMOVE NO. 4 BACK DOOR NAME PLATE |
for Type A:
![]() |
Apply protective tape to the back door panel in the area around the No. 4 back door name plate.
| *a | Wooden Blocks |
| *b | Protective Tape |
for Type B:
![]() |
Apply protective tape to the back door panel in the area around the No. 4 back door name plate.
| *a | Wooden Blocks |
| *b | Protective Tape |